Kepco MST 488 Programmer Manuale Utente Scaricare il pdf (Pagina 6)

228-1372 COND/CONFORM 052704

Conditions of Conformance

Programming Module

When this product is used in applications governed by the requirements of the EEC, the following restric-

tions and conditions apply:

1. For European applications, requiring compliance to the Low Voltage Directive, 73/23/EEC, this power

supply is considered a component product, designed for “built in” applications. Because it is incom-

plete in construction, the end product enclosure must provide for compliance to any remaining electri-

cal safety requirements and act as a fire enclosure. (EN61010-1:2001, Cl. 6, Cl. 7, Cl.8, and Cl. 9)

2. This power supply is designed for stationary installation either within an equipment rack or a KEPCO

Rack Adapter RA 55 or CA 400.

3. This power supply is considered a Class 1 (earthed) product. It is intended for use as part of equip-

ment meant for test, measurement and laboratory use, and is designed to operate from single phase,

three wire power systems. This equipment must be installed in a specifically designed KEPCO rack

adapter and within a suitably wired equipment rack, utilizing a three wire (grounded) mains connection.

See wiring section of this manual for complete electrical wiring instructions. (EN61010-1:2001,

Cl.6.10.1)

4. This power supply has secondary output circuits that are considered SELV.

5. This power supply employs a supplementary circuit protector in the form of a fuse mounted within its

enclosure. The fuse protects the power supply itself from damage in the event of a fault condition. For

complete circuit protection of the end product, as well as the building wiring, it is required that a pri-

mary circuit protection device be fitted to the branch circuit wiring. (EN61010-1:2001 Cl. 9.5)

6. Hazardous voltages are present within this power supply during normal operation. All operator adjust-

ments to the product are made via externally accessible switches, controls and signal lines as speci-

fied within the product operating instructions. There are no user or operator serviceable parts within

the product enclosure. Refer all servicing to qualified and trained Kepco service technicians.

1 2 3 4 5 6 7 8 9 10 11 ... 67 68

Nessun commento

Kepco MST 488 Programmer Manuale Utente Pagina 6